Nominal diameter | 3/8 ″ (10A) | |
Material connection | Inlet | Rc3 / 8 |
Discharge port | ||
Air connection | Supply port | Rc1 / 4 (with air cock) |
exhaust port | Rc3 / 8 (with muffler) | |
Service air pressure | 0.2 to 0.7 MPa | |
Discharge pressure | 0.7MPa | |
Discharge rate / cycle | 50mL | |
Slurry limit (maximum passing particle diameter) | 1mm or less | |
Mass |
DP-10BA ¡õ: 3.5kg DP-10BS ¡õ: 5.2kg DP-10BP ¡õ: 3.0kg |
¡¡¡¡¡¡
DP-10BA ¡õ series uses nylon (PA) as the material for the valve receiver. Pay attention to corrosion resistance. Not suitable for MEK etc. |
¡¡¡¡
Body (wetted part) material |
Diaphragm material |
||
C: Chloroprene (CR) |
N: Nitril Gum (NBR) |
T: Fluorocarbon resin |
|
A: Al alloy (ADC12) |
DP-10BAC (851743) |
DP-10BAN |
DP-10BAT |
S: Stainless (SCS14) |
DP-10BSC (851746) |
DP-10BSN |
DP-10BST |
P: Polypropylene (PPG) |
DP-10BPC |
DP-10BPN |
DP-10BPT |
Body (wetted part) material |
Diaphragm material |
||
H: Polyester type thermoplastic elastomer (TPEE) |
S: Polyolefin-based thermoplastic elastomer |
* H / T |
|
A: Al alloy (ADC12) |
DP-10BAH (851750) |
DP-10BAS (852674) |
DP-10BAH / T |
S: Stainless (SCS14) |
DP-10BSH |
DP-10BSS |
DP-10BSH / T |
P: Polypropylene (PPG) |
DP-10BPH |
DP-10BPS |
DP-10BPH / T |
* H / T is Diaphragm: Polyester thermoplastic elastomer (TPEE), Ball: Fluororesin (PTFE).
Note) Clicking the model / product number will display the parts list and parts exploded view.
Note) Download by right-clicking ''Save Target As'' ''''
Model |
DP-10BA |
DP-10BS |
DP-10BP ¡õ |
|
Ball valve |
DP-10B ¡õ¡õ ・ ・ ・ Same as diaphragm material |
|||
Valve seat |
A5056 |
SUS316 |
DP-10BPN ... NBR DP-10BPC ... CR |
|
Valve holder |
PA |
PPG |
||
Center disc |
A5056 |
PPG (SUS304 *) |
¡ïSUS304insert material ¡ï Initial self-lifting height is 1m for all models.
The maximum operating pressure of the body wetted part resin type (BP ¡õ) depends on the liquid temperature. Be sure to check the “Liquid temperature and maximum working pressure diagram”. |